Examine Error Codes If you find that your power heater turns on but then keeps shutting off, this could indicate that you are having water pressure issues.

Other reasons for high pressure are that your filtration system is trying to filter more water than it can handle or that there is a suction air leak. High pressure in your swimming pool means

ERROR LCD CODE Low pressure Malfunction of Gas change too low. Possible system system 1 A11 blockage High pressure Malfunction of Gas change too high.

Start the water pump before turning on the Machine to avoid any damage. - Press power on/off on LED controller to turn on/off machine. - During the first start of machine, please check if there is any water leakage in the piping connection system. Then set suitable temperature.

4. The high pressure protection switch is damaged. Troubleshooting: replace the high pressure protection switch. 5. The default water outlet temperature of the air source heat pump water heater unit is 55℃. If the temperature is set too high, the high-pressure protection failure will also occur.

Defective Pressure Sensor/switch (Most Common) The purpose of the pressure switch is to ensure that water is flowing through the unit before it allows the heater to turn on. The pool pump must be ON and your filter clean for the switch to close and allow voltage to pass through. Test the voltage reading on the pressure switch with a multimeter.

When talking about gas heaters, are commonly known as a popular choice for pool and or spa owners because of how quickly they can heat the water. The waiting time to enjoy the warmer water is virtually nonexistent because of the high output they can provide (when referring to the spa as a pool will require a little bit of wait time).

Medallion Energy 3055 Tech Park Way Deland, FL 32724 407-786-0000. Hours Mon-Fri: 8am - 7pm Saturday: 9am - 5pm Sunday: By Appointment

Offline - The Pentair cloud cannot connect to your pump. This could be caused by a power outage at the pump or router, or a loss of WiFi signal to the pump. Priming failure- This can be caused by a lack of water in the volute strainer basket. Overheat- The pump motor has detected an abnormally high internal temperature.

5.4 Except there is water level error, hot water tank temp sensor error, when there is other temp error, high and low pressure error protection, electric heater 

Poor water flow can sometimes trigger a High Pressure message, this means that the heat pump is creating heat but there is not enough water