6/14 · Home made puller to remove it

Shaft Sleeve Puller · Gear Pullers Wholesale 4inch 2-Jaw Gear Removal Tool Slide Gears Pulley And Flywheel Stanley Type Gear Puller · Auto Repair Tools High 

shaft shoulder. 5 Wait until the sleeve cools and slide the water slinger over the shaft, close to the motor. Place the spacer on top of the sleeve. The motor is now ready to be used on the pump. new style shaft sleeve without spacer 1 Remove water slinger. 2 Heat the shaft sleeve to 250°c to soften the glue and remove the sleeve.

J-41227. Tool Name: OUTPUT SHAFT SLEEVE REMOVER. Applications: 4T40E. 4T40E, 4T65E J-41227 is a two leg puller designed to locate behind the back lip of the sleeve for removal. This tool is required due to the limited access to the axle sleeve. The sleeve must be replaced when servicing the axle seals. Kent- Moore KM J-41227 Output Shaft Sleve

Remove and Replace leaking seal around the shift selector shaft without draining transmission fluid To remove and install shift shaft seal on select vehicles Genuine AC DELCO Seal Included 8657163 For use on these Transmissions: 180,180C (3L30) (4L30-E) Short Shaft Only 200, 200C, 200-4R 250, 250-C, 350, 350C 325,325-4L 375,400 (3L80), 425, 475

Installation and removal Lock nuts requiring a keyway are easy to install. Each nut is provided with four or eight equally spaced slots around their circumference to accommodate a hook or impact spanner. The designations of the appropriate spanners are listed in the technical specification for each product of the relevant product table.

You can easily remove the driveshaft on your jet ski by following these six simple steps: Read the service manual Remove the reverse bucket Remove the C-Clip (on Sea-Doos) Pull the pump out Pull the driveshaft out Remove the mid-shaft (if required – on WaveRunners) If you want to find out more about the process, keep reading.

Cartridge seals are designed for rapid installation on and removal from pump shafts. The cartridge seal is an arrangement of seal components on a shaft sleeve and in a seal gland constituting a single unit that is usually assembled and pre-set at the factory.

1/4 · Shows two methods for quickly and successfully removing a shaft sleeve.

The spare part code for the shaft sleeves is 075. We provide slurry pump shaft sleeves made of 4Cr13, ceramic coating, tungsten carbide coating, and stainless steel to meet different applications. The slurry pump shaft sleeve can protect the pump shaft from mud abrasion and corrosion and prolong the service life of the pump.

8/1 · About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy & Safety How works Test new features