are activated, to compensate for rotor and brake pad wear and to keep the running clearance constant. During pad or rotor maintenance, the technician manually sets the system's initial non-braked position. The total running clearance (the sum of clearances on both sides of the rotor) should be between 0.024 to 0.043 in. (0.6 to 1.2 mm).

Discussion Starter · #1 · Aug 24, 2022. Front and Rear Brake Disc Rotors: Brake hose mounting bolt (A) from the damper: ( xx Ibf-ft) Brake caliper bracket mounting 2 bolts (B): ( xx Ibf-ft) Front and Rear Brake Pads: Flange bolt (A) while holding the caliper pin (B) with a wrench: ( xx Ibf-ft)

Turning brake rotors is a term that is used to describe machining, or lathing, brake rotors down to remove the excess brake material from your pads and to prevent warping and grinding, thus extending the life of your brake pads. Turning a rotor allows for smooth braking action and creates less heat then those that are warped.

Torque Specs for Brake Rotor Bolts Kiffer_XR250R Posted August 29, I need the torque specs for the front and rear brake rotor bolts. The service manual and the owner's manual do not have them listed anywhere. I know the bolts need thread-lock (bolts had residue from factory), but I have no idea for what the torque values are.

When reinstalling the brake caliper you must torque the caliper bolts to 25 ft-lbs. If you need to remove the calipers banjo bolt it will need to be tightened 

2011. 3. 4. · My Harley dealer tell me to torque at 120 lbs for the primary cover, and that's o.k But i don't know if it was in ft or inch. Primary cover torque is rated in inch lbs- 108-120 inch lbs.

Front rotors:-nominal thickness - 1.140"-discard thickness - 1.080" Source: MOTOR Brake specifications guide, Note - There has been conflicting torque specs for the rear caliper bracket bolts. GMSI and Motor show 148ft lbs, while a Helms book shows 89ft/lbs. At the time of this edit, the official answer is unknown.

The screws holding the rotors in place I never use a torque wrench setting for. Does anyone know the toque specs for the rear brakes?

This means that removal and installation is also the same. The brake caliper gets torqued down to 22 ft-lbs and the brake bracket gets tightened to 56 ft-lbs.

You could buy a service manual from Haynes, they list a lot of torque specs in them. Did you try to Google it? I did and found this, don't 

2018. 8. 8. · I picked up an Enforcer front wheel for my bike. I'm installing Arlen Ness rotors on it. The torque spec for my 09 stock wheel is 16 to 24lbs, but it seems to low. At 24lbs. it doesn't