DIN 580 Specification specifies the properties of steel and stainless steel eyebolts and provides information on their correct use in lifting operations (as part of slings and as load handling equipment). Eye bolts according to this standard can be used in a temperature range from −20 ° C to +200 ° C without any restriction of the load capacity.

The following guidelines for DIN 580 lifting eye bolts must be observed in addition to the maximum load values given in the table:The eye bolt mus JW Winco’s new handbook will support designers and engineers with the largest selection of standard parts. Our handbook has the most comprehensive number of standard parts with over 75,000

Metric DIN 444 Eye Bolts Visit our online store for product availability Dimensions of Metric DIN 444 Eye Bolts Thread d1 M5 M6 M8 M10 M12 M16 M20 M24 (M27) M30 (M33) M36 (M39) b +2P 0.8 1 1.25 1.5 1.75 2 2.5 3 3 3.5 3.5 4 4 16 18 22 26 30 38 46 54 60 66 - - - 0 - - 28 32 36 44 52 60 66 72 78 84 90

Hex key cover plate. Zinc plated steel. GN 581 swivel lifting eye bolts offer a high load carrying capacity and are tested to meet high safety standards. The 

Material Lifting eye bolts according to the present Standard shall be manufactured solely fron C 15 steel according to DI! 17210. They must be nomalized and possess a notched bar Impact strength of 80 m/cn (ISO round notch test bar) or or 90 n/cn2 (DVM test bar). 2.2. Lifting eye bolts must be clean drop forgings.

Metric DIN 444 Eye Bolts are bolts with an eye (loop/ring) at one end and a threaded shank at the other. They are threaded into a pre-tapped hole or secured with a nut to a structure so that a rope or cable can be attached to the loop end. Only eye bolts with shoulders should be used to support angular loads.

WARNING. • Load may slip or fall if proper eye bolt assembly and lifting procedures are not used. • A falling load can seriously injure or kill.

The above eye bolts comply to British Standards as follows: Short Shank code WIR15112 to BS 4278 Part 1 1984. [The scope of this standard starts at M12 – the M10 is machined from an M12 forging].

1.DIAGRAM 1 It is important to ensure proper alignment of the installed eye bolts before lifting. Referring to DIAGRAM 1: an eye bolt can be turned ¼ turn to ensure proper lifting angles. Never pull across the flats of an eye bolt. 2. TABLE 1 makes reference to the safe working load for shoulder pattern eye bolts.

Regular Nut Eye Bolt Shoulder Nut Eye Bolt Machinery Eye Bolt G-291 G-277 G-279 Important Safety Information— Read and Follow Inspection/Maintenance Safety: † Always inspect eye bolt before use. † Never use eye bolt that shows signs of wear or damage. † Never use eye bolt if eye or shank is bent or elongated.

conformance to specifications. • Available with UNC Class 2A thread only. • Eyebolt shanks should never be undercut or eyebolt shank diameters reduced.