Jaw Quarry Tooth Long 2022-02-22 Popular C Jaw Crusher Liners : Item Names: Jaw Plate s ,Stationary Jaw Tooth, Movable Jaw Die Fixed Jaw, Swing Jaw Plate , Jaw Fixed, Jaw Moveable , Cheek Plate , Side Plate,Jawface Fixed, Crusher Jaw Loose Casting Material: Austensti

Lift the new jaw plate, and start the crane to hang the moving plate and the fixed plate separately. Install the clamps, place the clamps in place, and tighten the screws. Tighten the stationary plate screws and install the side plates. Adjust the gap of the discharge port. Start the jaw crusher and vibrate the mine for trial operation.

The nip angle is the angle between the fixed and moving jaw plates. Our CJ crushers have an optimum nip angle in the 16-23 degree range. Product picture 

Jaw Crusher Wear Parts: Item Names: Jaw Plate s ,Stationary Jaw Tooth, Movable Jaw Die Fixed Jaw, Swing Jaw Plate ,Jaw Fixed, Jaw Moveable , Cheek Plate , Side Plate Casting Material: Austenstic Manganese Steel (Mn14, M14Cr2, Mn18Cr2, Mn22Cr2)

If something that the jaw crusher cannot crush gets into the crushing chamber accidentally and it cannot pass through the jaw, the toggle plate will crush and prevent the whole machine from further damage. Minimal maintenance requirements. Inquiry This Item Looking for aftermarket parts? +86 159 5822 9409 / +86 138 6784 5744 [email protected]

The main working part of the jaw crusher is two jaw Crusher plates. One is a fixed jaw, which is vertically (or slightly inclined at the upper end) fixed on the front wall of the machine body, and the other is a movable jaw. The position is inclined and the fixed jaw plate forms a large crushing cavity at the bottom.

The cheek plates lining the inside of the jaw crusher cavity are subject to both high stress (during the crushing cycle) and low stress (between crushing 

Jaw crusher part includes: fixed jaw plate swing jaw plate upper check plate lower check plate toggle plate. Toggle seat &liner. Material: high manganese steel. Jaw Crusher – Heavy Industry Jaw crusher movement is obtained by using a pivot point located at one end of the

Jaw Plates are the mainly wear-resistant parts for jaw crusher. Zhejiang Tonghui Crushing Machinery Co., Ltd is the professional supplier of high-chromium alloy cast iron, high manganese steel, super high manganese steel and other wear resistant Chromium alloy cast iron from 1993.

Jaw Plate PE 150 x 250 / Jaw Crusher 1 set. Preorder Tooth Plate Jaw Crusher Penghancur Batu Sparepart 1 Set 2 Pcs PS1218. Rp1.650.000.

Introduction:Jaw plate is the main wear part of jaw crusher, which is divided into moving jaw plate and fixed jaw plate TOUGHING’s jaw plate and cheek plate is manufactured with high