Note - X denotes that the Taper Lock Bushing is also available with metric bore size key Metric Split Taper Bushings. Hub. L. U. T. Large. Small. H. V.

The bushings are stocked in all popular bore sizes, including metric bores, within the bore range for a particular bushing. Bush. Torque. Capacity. (In.-Lbs.) ( 

Taper-Lock® and QD® bushing installation is critical to good belt drive performance. Improper installation can damage the bushing and/or the sprocket/sheave. Sprockets/sheaves are commonly mounted to a shaft with a tapered bushing that fits a mating tapered bore in the

no . 1008 to 3030 taper bushings dimensions c (hub diam.) d (bolt circles) b a l m a a f section a-a position of screw to tighten bushing 8º taper included angle set screw for tightening on shaft: hub half of hole threaded, bushing half of hole not threded for removing from shaft: bushing half of hole threaded. hub half of hole not threaded

4 Degree Taper Easy on/Easy off Manufactured precisely to industry stan dards Conventional or Reverse QD Bushings Conventional Mounting Easy On Place bushing in product Align clearance holes in product with threaded holes in bushing Install screws and lockwashers thru clearance holes, finger tight Slide assembly onto shaft, flange first

Taper lock bushings are designed with a split through the bushing and a gradual 8° taper angle that creates the equivalent of a string fit when installed into a 

Commercial Sales(863) 337-4984 Phones currently unavailable Mon-Fri 8-3PM ET Min $20.00

The barrel of the split tapered bushing is split in two places and is keyed to the shaft. The barrel OD is also keyed to the drive component as well. The 

Mount these hubless bushings flush into your sprocket or pulley for a slim profile with no protruding screws. They are for use with taper-lock sprockets of the same bushing style. As you tighten the included set screws, the bushing grips the shaft and pulls it into your sprocket or pulley.. For technical drawings and 3-D models, click on a part number.

QD bushings are capable of conventional mounting with the flange outboard and reverse mounting to where the flange is inboard and utilize a single split that extends through the entire bushing length. Our QD bushings interchange with other brands and are made from high-grade steel that has been precision machined for perfect application fitment

IMPORTANT – BE SURE TAPERED CONE SURFACES OF QD BUSHING AND INSIDE OF SHEAVE OR SPROCKET HUB ARE DRY AND FREE Assemble pull-up bolts and lock washers .