the V-Ring material, the V-Ring in general requires radial retention. The speed when radial retention is required is also dependent on the degree of stretch of the V-Ring. The radial retention can be designed as a recess, in which the V-Ring body fits, or consist of a number of separate clamping segments. V-Ring Type Diameter d5 A, S d1+ 0.5 x c

The V-Ring® fits directly onto the shaft and seals axially against a counterface, such as shaft collar, thrust washer or bearing face. V-Ring® Technical drawing. For full engineering

Assembly of the v-ring is easy and does not require much time. The ring is expanded and pulled over the shaft. It is then brought into position with a rounded 

AV-ring consists of a seal body, a flexible, coni- cal-shaped sealing lip and an integral, resilient. "hinge" (→ fig. 2). It is stretched and installed.

V-Ring® for rotary shafts. A unique all rubber seal for rotary shafts, V-Ring® offers the perfect solution to prevent ingress of media including dirt, dust and 

For sealing dynamic, rotary motion. V ring seal installation example. V-ring installation example. V ring seal view. V-rings are flexible rubber seals that 

Against the body. DCO application you should put some sort of a lubricant on the VCL. Make sure that there is lebra's the Deanna. Put the hub assembly over the shaft.

Which way do you put oil seal? When installing an oil seal, the lip of the seal should be facing the inside of the housing to prevent oil from bypassing the seal. This would cause oil to leaks. The lip will scrape along the shaft as it turns, helping to keep oil from leaking.

Install the cap onto the base and tighten the cap bolts to the torque marked in the table (fig. 4a). 12. Tighten the attachment bolts in the housing base (fig.

V-Rings are made entirely of rubber without fabric or sheet metal reinforcement. They are, therefore, particularly easy to install. V-Rings can be stretched and 

The construction of a v-ring seal is divided into three parts: a. the body b. the lip c. the hinge. ERIKS offers v-rings manufactured with four standard profiles. The S type v-rings are designed for shaft sizes up to 200 mm. The A type v-rings are designed for shaft sizes up to mm.