Як запустити tracert?

by admin


How to use the tracert command?

Take the following steps to run a traceroute in Microsoft® Windows®:

  1. Press Windows key + R to open the Run window.
  2. Enter cmd and press Enter to open a Command Prompt.
  3. Enter tracert, a space, then the IP address or web address for the destination site (for example: tracert www.lexis.com).
  4. Press Enter.

How to specify hops in tracert?

To set the maximum number of hops to 45, for example, you would type tracert /h 45 catchpoint.com . /w — This sets the amount of time that the command will wait at a hop before timing out, measured in milliseconds. The default is 4 seconds (4,000 milliseconds).

How to stop tracert ping?

Many wonder how to stop a tracert quickly. The usual method is to press Ctrl+Shift+6 and then X.

How to read the tracert results?

  1. Hop Number – This is the first column and is simply the number of the hop along the route. …
  2. RTT Columns – The next three columns display the round trip time (RTT) for your packet to reach that point and return to your computer. …
  3. Domain/IP column – The last column has the IP address of the router.

В приложении Network Utilities перейдите в меню в левом верхнем углу и откройте раздел «Traceroute». Введите там в строке поиска домен или IP-адрес сервера, до …
Засіб діагностики TRACERT визначає маршрут до місця призначення, надіславши протокол керівних повідомлень Інтернету (ICMP) echo пакетів до місця призначення. У …